Intelligent transport systems — Localized communications — Communication protocol messages for global usage
Introduction: This document belongs to a set of International Standards for Intelligent Transport Systems (ITS) and Cooperative ITS (C-ITS). An introduction to this set of International Standards is provided in ISO 21217. Localized communications, i.e. communications without networking through nodes, and service advertisement are essential protocol functionalities in C-ITS. ISO and IEEE developed protocols with similar functionality, i.e. the — ISO Fast Networking & Transport Protocol (FNTP) standardized in ISO 29281-1; — IEEE WAVE Short Message Protocol (WSMP) standardized in IEEE 1609.3[15], — ISO Fast Service Advertisement Protocol (FSAP) standardized in ISO 24102-5, — IEEE WAVE Service Advertisement (WSA) standardized in IEEE 1609.3[15], where ISO considered the architectural context of an ITS station specified in ISO 21217:2014, and IEEE considered the architectural context of a WAVE device specified in IEEE 1609.0[13]. Although initial versions of these protocols from ISO and IEEE are very similar, there are differences in details of the message formats and the functionality. These differences were identified by the EU/US task force HTG 3, from which a recommendation resulted to harmonize the protocols[20]. The result of harmonization of FNTP with WSMP, and of FSAP with WSA is presented in this document, distinguishing interoperability modes, and enhanced features specified in this document. With reference to this document, the initial editions of ISO 29281-1 and IEEE 1609.3 were rev
Scope: This document specifies: — the Localized Message (LM) format: an NPDU of a networking & transport layer protocol that does not support routing of a packet through a network; — the Service Advertisement Message (SAM): an APDU to be transported in an LM, for example; — the Service Response Message (SRM): an APDU acknowledging a SAM that offered a service based on an ITS application class[2] to be transported in an LM, for example; — related basic requirements for procedures. Specifications are partly made by normative references to IEEE 1609.3(TM)-2016. NOTE These message format specifications and basic procedures need to be complemented by complete procedures and SAP specifications according to the context of usage, i.e. an ITS station specified in ISO 21217, or a WAVE device specified in IEEE 1609.0[13] or any other context.