ISO 16486-3-2025 PDF

ISO 16486-3-2025 PDF

Plastics piping systems for the supply of gaseous fuels-Unplasticized polyamide (PA-U) piping systems with fusion jointing and mechanical jointing-Part 3: Fittings

$60.00 $120.00 -50%
Product Code: ISO 16486-3
Stock In Stock
Edition: 3.
Published: 01/2025
Number of Pages: 28
File Size: 1 file, 1 Byte

Available Options

Product Description

Systèmes de canalisations en matières plastiques pour la distribution de combustibles gazeux — Systèmes de canalisations en polyamide non plastifié (PA-U) avec assemblages par soudage et assemblages mécaniques — Partie 3: Raccords

Introduction: This document specifies the requirements for a piping system and its components made from unplasticized polyamide (PA-U), which is intended to be used for the supply of gaseous fuels. NOTE 1 Additional information about the suitability of PA-U pipe systems for hydrogen and its admixtures is given in ISO 16486-1:2023, Annex D. Requirements and test methods for material and components of the piping system, are specified in ISO 16486-1, ISO 16486-2 and ISO 16486-4. Characteristics for fitness for purpose of the system and generic fusion parameters are covered in ISO 16486-5. Recommended practice for installation is given in ISO 16486-6, which will not be implemented as a European Standard under the Vienna Agreement. NOTE 2 Recommended practice for installation is also given in CEN/TS 12007-6,[3] which has been prepared by Technical Committee CEN/TC 234, Gas infrastructure. Assessment of conformity of the system is covered in ISO/TS 16486-7 . ISO 16486-1, ISO 16486-2, ISO 16486-3, ISO 16486-5, ISO 16486-6, ISO/TS 16486-7 and ISO/TS 16486-8 have been prepared by ISO/TC 138/SC 4. ISO 16486-4 has been prepared by ISO/TC 138/SC 7. © ISO 2025 – All rights reserved

Scope: This document specifies the physical and mechanical properties of fittings made from unplasticized polyamide (PA-U) in accordance with ISO 16486-1, intended to be buried and used for the supply of gaseous fuels. It also specifies the test parameters for the test methods to which it refers. The ISO 16486 series is applicable to PA-U piping systems, the components of which are connected by fusion jointing and/or mechanical jointing. In particular, this document lays down dimensional characteristics and requirements for the marking of fittings. In conjunction with the other parts of the ISO 16486 series, this document is applicable to PA-U fittings, their joints, joints with components of PA-U and joints with mechanical fittings of other materials, and to the following fitting types: — fusion fittings (electrofusion fittings and butt fusion fittings), and — transition fittings.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16486-3-2025 PDF

ISO 16486-3-2025 PDF

$60.00 $120.00