Food products - Determination of the total nitrogen content by combustion according to the Dumas principle and calculation of the crude protein content - Part 2: Cereals, pulses and milled cereal products
Introduction: For a long time, the Kjeldahl method has been the most frequently used method for the determination of the protein content of food products. In recent years, the Dumas method has gained importance compared to the Kjeldahl method because it is faster and does not use dangerous chemicals. Although the principles of the two methods are different, both measure the nitrogen content of the product. Nitrogen content can be converted into protein content by using an appropriate factor. The value of this factor varies depending on the relative amounts of different proteins and their amino-acid composition in a given product. Neither the Dumas nor the Kjeldahl method distinguishes between protein and non-protein nitrogen. In most cases, results obtained by the Dumas method are slightly higher than those of the Kjeldahl method. This is because the Dumas method measures almost all of the non-protein nitrogen, whereas the Kjeldahl method measures only a part of it. Taking into consideration that the protein content of a product calculated by both methods only approximates to the true value, it is a matter of discretion which one is accepted. The best solution is to use a second factor for the elimination of the systematic error caused by the non-protein nitrogen content of the different products. However, this second factor has to be determined for each product like the existing factors which indicate the ratio of the protein content to the nitrogen content. © ISO 2016 – All rights reserv
Scope: This part of ISO 16634 specifies a method for the determination of the total nitrogen content and the calculation of the crude protein content of cereals, pulses and milled cereal products. This method, like the Kjeldahl method (see References [1] and [6]), does not distinguish between protein nitrogen and non-protein nitrogen. For the calculation of the protein content, various conversion factors are used (see 3.2).