Non-destructive testing — Ultrasonic testing — General principles
Introduction: The following International Standards are linked: ISO 16810, Non-destructive testing — Ultrasonic testing — General principles ISO 16811, Non-destructive testing — Ultrasonic testing — Sensitivity and range setting ISO 16823, Non-destructive testing — Ultrasonic testing — Through-transmission technique ISO 16826, Non-destructive testing — Ultrasonic testing — Testing for discontinuities perpendicular to the surface ISO 16827, Non-destructive testing — Ultrasonic testing — Characterization and sizing of discontinuities ISO 16828, Non-destructive testing — Ultrasonic testing — Time-of-flight diffraction technique for detection and sizing of discontinuities © ISO 2024 – All rights reserved
Scope: This document specifies the general principles for the ultrasonic testing of industrial products that permit the transmission of ultrasound. The specific conditions of application and use of ultrasonic testing, which depend on the type of product to be tested, are described in documents which can include: — product standards; — specifications; — codes; — contractual documents; — written procedures. This document specifies the minimum applicable requirements, unless otherwise specified in the referencing documents. This document does not specify: — extent of testing and scan plans; — acceptance criteria. This document describes only conventional probes, however, the general principles for ultrasonic testing also apply to ultrasonic testing using array techniques. If array techniques are used, then additional steps or verifications can be needed.