ISO 16828-2025 PDF

ISO 16828-2025 PDF

Non-destructive testing-Ultrasonic testing-Time-of-flight diffraction technique for detection and sizing of discontinuities

$96.50 $193.00 -50%
Product Code: ISO 16828
Stock In Stock
Edition: 2.
Published: 07/2025
Number of Pages: 28
File Size: 1 file, 1 Byte

Available Options

Product Description

Non-destructive testing — Ultrasonic testing — Time-of-flight diffraction technique for detection and sizing of discontinuities

Introduction: The following standards on ultrasonic testing developed by ISO/TC 135 are related. ISO 16810, Non-destructive testing — Ultrasonic testing — General principles ISO 16811, Non-destructive testing — Ultrasonic testing — Sensitivity and range setting ISO 16823, Non-destructive testing — Ultrasonic testing — Through-transmission technique ISO 16826, Non-destructive testing — Ultrasonic testing — Testing for discontinuities perpendicular to the surface ISO 16827, Non-destructive testing — Ultrasonic testing — Characterization and sizing of discontinuities © ISO 2025 – All rights reserved

Scope: This document specifies the general principles for the application of the time-of-flight diffraction (TOFD) technique for both detection and sizing of discontinuities in low-alloyed carbon steel components. This document also applies to other types of materials, provided the application of the TOFD technique is performed with necessary consideration of geometry, acoustical properties of the materials, and the test sensitivity. Although this document is applicable, in general terms, for discontinuities in materials and applications covered by ISO 16810, it contains references to the application on welds. This approach has been chosen for reasons of clarity as to the probe positions and directions of scanning. Unless otherwise specified in the referencing documents, the minimum requirements specified in this document apply. Unless explicitly stated otherwise, this document is applicable to the following categories of test objects as specified in ISO 16811: — category 1, without restrictions; — categories 2 and 3, specified restrictions apply (see Clause 10); — categories 4 and 5 require special procedures, which are also addressed (see Clause 10). NOTE Techniques for the use of TOFD for weld testing are described in ISO 10863 and the related acceptance criteria are given in ISO 15626.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16828-2025 PDF

ISO 16828-2025 PDF

$96.50 $193.00