Road vehicles — Tachograph systems — Part 1: Electromechanical components
Introduction: This document supports and facilitates the communication between electronic control units (ECUs) and a digital tachograph. The digital tachograph concept is based upon a recording equipment storing data, related to the activities of the various drivers driving the vehicle, on which it is installed. During the normal operational status of the recording equipment, data stored in its memory are accessible to different entities (drivers, authorities, workshops, transport companies) in different ways (displayed on a screen, printed by a printing device, downloaded to an external device). Access to stored data is controlled by a smart card inserted in the tachograph. A typical tachograph system is shown in Figure 1. Key data and service IF connector standardized in ISO 16844-1 CAN-based data IF including parameter groups standardized in ISO 16844-4 electrical data and service IF requirements standardized in ISO 16844-2 optional CAN-based service IF standardized in ISO 16844-6 communication interface between motion sensor and RE standardized in ISO 16844-3 data identifier (DID) specification for the optional service IF standardized in ISO 16844-7 Figure 1 — Typical ISO 16844-conformant tachograph system © ISO 2022 – All rights reserved
Scope: This document specifies the mechanical dimensions of mandatory connectors and optional connectors used by the recording equipment for the data and the service interfaces. This includes, in particular, the connection to the CAN-based in-vehicle networks.