ISO 16890-4-2022 PDF

ISO 16890-4-2022 PDF

Air filters for general ventilation-Part 4: Conditioning method to determine the minimum fractional test efficiency

$48.00 $96.00 -50%
Product Code: ISO 16890-4
Stock In Stock
Edition: 2ND
Published: 07/2022
Number of Pages: 18
File Size: 1 file, 1 Byte

Available Options

Product Description

Air filters for general ventilation — Part 4: Conditioning method to determine the minimum fractional test efficiency

Introduction: The effects of particulate matter (PM) on human health have been extensively studied in the past decades. The results are that fine dust can be a serious health hazard, contributing to or even causing respiratory and cardiovascular diseases. Different classes of PM can be defined according to the particle size range. The most important ones are PM10, PM2,5 and PM1. The U.S. Environmental Protection Agency (EPA), the World Health Organization (WHO) and the European Union (EU) define PM10 as PM which passes through a size-selective inlet with a 50 % efficiency cut-off at 10 µm aerodynamic diameter. PM2,5 and PM1 are similarly defined. However, this definition is not precise if there is no further characterization of the sampling method and the sampling inlet with a clearly defined separation curve. In Europe, the reference method for the sampling and measurement of PM10 is described in EN 12341. The measurement principle is based on the collection on a filter of the PM10 fraction of ambient PM and the gravimetric mass determination (see Reference [7]). As the precise definition of PM10, PM2,5 and PM1 is quite complex and not easy to measure, public authorities, such as the U.S. EPA or the German Federal Environmental Agency (Umweltbundesamt), increasingly use in their publications the simpler denotation of PM10 as being the particle size fraction less than or equal to 10 µm. Since this deviation to the above-mentioned complex “official” definition does not have a significant im

Scope: This document establishes a conditioning method to determine the minimum fractional test efficiency. It is intended to be used in conjunction with ISO 16890-1, ISO 16890-2 and ISO 16890-3, and provides the related test requirements for the test device and conditioning cabinet as well as the conditioning procedure to follow. The conditioning method described in this document is referring to a test device with a nominal face area of 610 mm × 610 mm (24 inches × 24 inches). This document refers to particulate air filter elements for general ventilation having an ePM1 efficiency less than or equal to 99 % and an ePM10 efficiency greater than 20 % when tested according to the procedures defined within the ISO 16890 series. NOTE The lower limit for this test procedure is set at a minimum ePM10 efficiency of 20 % since it will be very difficult for a test filter element below this level to meet the statistical validity requirements of this procedure. Filter elements used in portable room-air cleaners are excluded from the scope of this document.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16890-4-2022 PDF

ISO 16890-4-2022 PDF

$48.00 $96.00