General requirements for the competence of reference material producers
Introduction: Reference materials (RMs) are used in all stages of the measurement process, including for method validation, calibration and quality control. They are also used in interlaboratory comparisons for method validation and for assessing laboratory proficiency. The demonstration of the scientific and technical competence of reference material producers (RMPs) is a basic requirement for ensuring the quality of RMs. The demand for new RMs of higher quality is increasing as a consequence of both the improved precision of measuring equipment and the requirement for more accurate and reliable data in the scientific and technological disciplines. It is not only necessary for RMPs to provide information about their materials in the form of RM documents, but also to demonstrate their competence in producing RMs of appropriate quality. This International Standard outlines the general requirements for the producers of RMs, including certified reference materials (CRMs). It supersedes ISO Guide 34:2009 and is aligned with the relevant requirements of ISO/IEC 17025. Further guidance (e.g. concerning the content of certificates and the design of characterization, homogeneity and stability studies) is provided in ISO Guide 31 and ISO Guide 35. While the approaches outlined in ISO Guide 31 and ISO Guide 35 meet the relevant requirements of this International Standard, there might be alternative ways to achieve compliance to this International Standard. RMPs that comply with this International St
Scope: This International Standard specifies general requirements for the competence and consistent operation of reference material producers. This International Standard sets out the requirements in accordance with which reference materials are produced. It is intended to be used as part of the general quality assurance procedures of the reference material producer. This International Standard covers the production of all reference materials, including certified reference materials. NOTE Reference material producers, regulatory authorities, organizations and schemes using peer assessment, accreditation bodies and others can also use this International Standard in confirming or recognizing the competence of reference material producers.