ISO 17104-2026 PDF

ISO 17104-2026 PDF

Rotary tools for threaded fasteners-Impulse and impulsing tools-Performance test method

$129.00 $258.00 -50%
Product Code: ISO 17104
Stock In Stock
Edition: 1.
Published: 02/2026
Number of Pages: 44
File Size: 1 file, 2 MB

Available Options

Product Description

Rotary tools for threaded fasteners — Impulse and impulsing tools — Performance test method

Introduction: This document is intended to — enable the manufacturers of power tools to offer their products under standardized technical specifications, and — give users of threaded fasteners a method for evaluating and specifying the performance of power assembly tools. This document is a fundamental test procedure, with no attempt to set acceptance criteria. Any minimum performance requirements are the responsibility of the user to meet the demands of the particular application for which the tool is intended for use. Unlike the previous Technical Specification, this document is applicable to tightening tools of any power source within its scope. However, the test does require that the tool under test is capable of being set to a specific shut-off point. Additional statements have been introduced to point out the differences between correlated torque derived from clamp force and inbuilt indication or control systems that now exist in a number of tools. Annex A explains the basis for the use of clamp force rather than torque for testing the performance of fastener assembly tools that apply torque in a discontinuous method. Annex B explains the principle of electric impulsing tools which operate in a different way to hydraulic impulse tools. Annex C includes preferred torque values that may be used for testing. Annex D gives an example format for the test report. Annex E provides background to the testing performed during the creation of this document. This document includes some changes t

Scope: This document specifies a laboratory performance test method for hydraulic impulse and electric impulsing tools for installing threaded fasteners in a laboratory environment, and for power assembly tools (referred throughout the document as “tools”) for installing threaded fasteners. It gives instructions on the procedure, performance parameters to test and how to evaluate and present the test data. It also provides a method for the measurement of torque repeatability (scatter) — over a range of torque rates as specified in this document, and — over a range of torque adjustment as defined by the manufacturer. It gives instructions on equipment parameters, what to test for and how to evaluate and present the test data. It is applicable to tools — of any power source, such as pneumatic or electric, including battery-powered, — which apply torque in discontinuous increments, and — within the torque range 0,5 N·m to 800 N·m. Outside this range, it is acceptable to modify the test method providing that the modification is documented in the test report. It is not applicable to — impact wrenches, and — ratchet wrenches or wrenches with ratcheting clutches. The relationship between torque measurements and clamp force-based tests is commented on in Annex A. The use of tools using discontinuous operation of the motor to provide torque impulses is discussed in Annex B. It requires manufacturers to perform tests over their defined torque range of the tool; however, it allows users to perform single point tests in order to minimize the number of test joints necessary for a wide range of test torque levels. A list of preferred test torque levels is provided in Annex C.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17104-2026 PDF

ISO 17104-2026 PDF

$129.00 $258.00