Surface chemical analysis — Depth profiling — Method for sputter rate determination in X-ray photoelectron spectroscopy, Auger electron spectroscopy and secondary-ion mass spectrometry sputter depth profiling using single and multi-layer thin films
Introduction: The sputtering rate in surface chemical analysis is generally determined from the quotient of sputtered depth, measured using stylus profilometry, and sputtering time. However, for multi-layered thin films, only the average sputtering rate is determined by this method. Therefore, this method is difficult to apply to multi-layered thin films comprised of materials with different sputtering rates. Sputtering rates are also affected by various experimental parameters so that it is difficult for them to tabulate and to be used for sputter depth calibrations. For higher accuracies, it is important for sputtering rates to be determined under specific experimental conditions for each laboratory for sputter depth calibration. Sputter rates should be determined using single-layers that are much thicker than the projected range of the sputtering ions so that the surface transient effect is negligible or by using multi-layered thin films where the effect of surface transient phenomena can be excluded, and interface transients can be minimized. This document is developed for the calibration of sputtered depth by determining the ion sputtering rate for depth profiling measurement with Auger electron spectroscopy (AES), X-ray photoelectron spectroscopy (XPS), and secondary ion mass spectrometry (SIMS) using single- and multi-layer thin films. The measured ion sputtering rate can be used for the prediction of ion sputtering rates for a wide range of other materials so that depth scales or s
Scope: This document specifies a method for the calibration of the sputtered depth of a material from a measurement of its sputtering rate under set sputtering conditions using a single- or multi-layer reference sample with layers of the same material as that requiring depth calibration. The method has a typical accuracy in the range of 5 % to 10 % for layers 20 nm to 200 nm thick when sputter depth profiled using AES, XPS and SIMS. The sputtering rate is determined from the layer thickness and the sputtering time between relevant interfaces in the reference sample and this is used with the sputtering time to give the thickness of the sample to be measured. The determined ion sputtering rate can be used for the prediction of ion sputtering rates for a wide range of other materials so that depth scales and sputtering times in those materials can be estimated through tabulated values of sputtering yields and atomic densities.