Petroleum products and other liquids - Ethanol - Determination of total acidity by potentiometric titration
Introduction: Diluted hydrous solutions of organic acids, e.g. acetic acid, can corrode many materials. Thus, it is necessary to determine and keep at low values the acid content in the final product. An ethanol sample can have organic acids from the productive process, from its handling, contained in additives, or due to sample degradation or contamination. The relative content of those components can be determined by titration with a strong alkaline solution. The numeric result of total acidity is a measure of the amount of acid components in the sample. Total acidity is used as a quality control parameter of final product to prevent long-run corrosion problems. For this reason, final product obtained from a blend of ethanol and other fuels has to have a limited acidity. © ISO 2014 – All rights reserved
Scope: This International Standard specifies a test method for the determination of total acidity of ethanol by potentiometric titration. The total acidity is reported as acetic acid mass, in milligrams, per ethanol volume, in litres, or as mass percent of acetic acid (% m/m), if the density of ethanol is known. NOTE 1 For the purposes of this International Standard, the terms “% m/m” and “% v/v” are used to represent the mass fraction and the volume fraction of a material, respectively. NOTE 2 This method was evaluated with ethanol samples with different water contents (0,7 % m/m and 7 % m/m) and acidity values (5 mg to 50 mg HAc per litre of sample). 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 total acidity amount of acids contained in the ethanol sample, calculated as acetic acid, determined by potentiometric titration with a strong alkaline solution, as given in this International Standard 3 Reagents and materials 3.1 Deionized water, with a maximum conductivity of 1 μS/cm, Grade 2 or equivalent. 3.2 Potassium hydrogen phthalate (KHC8H4O4), standard grade. 3.3 Solution of lithium chloride (LiCl) in ethanol, 1 mol/l to 3 mol/l. 3.4 Buffer solution, with pH 4 and pH 7. NOTE The above values of pH are only indicative. The values shown on the buffer certificates are those which are intended to be used in the analysis. 3.5 Hydrochloric acid solution (HCl), 1,0 mol/l, a solution prepared in accordance with the following or a commercially available standardized hydrochloric acid solution of equivalent concentration. — In order to prepare HCl, 1,0 mol/l, transfer (84,0 ± 0,5) ml of concentrated hydrochloric acid (37 % v/v) to a 1 000 ml volumetric flask containing about its half capacity of water (3.1). Complete the volume and homogenize the solution. Stock the solution in an amber flask at a temperature below 25 °C. — This solution has a 6 mo shelf life. INTERNATIONAL STANDARD ISO 17315:2014(E) © ISO 2014 – All rights reserved ISO 17315:2014(E) 3.6 Sodium hydroxide solution (NaOH), 1,0 mol/l, a solution prepared in accordance with the following or a commercially available standardized sodium hydroxide solutio