ISO 17536-1-2015 PDF

ISO 17536-1-2015 PDF

Road vehicles - Aerosol separator performance test for internal combustion engines - Part 1: General

$13.00 $26.00 -50%
Product Code: ISO 17536-1
Stock In Stock
Edition: 1.
Published: 12/01/2015
Number of Pages: 30
File Size: 1 file, 537 Bytes

Available Options

Product Description

Road vehicles - Aerosol separator performance test for internal combustion engines - Part 1: General

Introduction: Engine crankcase blowby is composed of combustion exhaust gases which have escaped to the crankcase via piston ring seals and lube oil aerosols generated by thermal and mechanical action within the engine. These gases need to be vented from the crankcase to prevent a build-up of high pressure. The constituents of vented engine blowby gases are recognized as an undesirable contaminant and technology for their containment is therefore evolving. The device used to separate oil aerosols from the blowby typically releases cleaned gases to atmosphere or alternatively returns the cleaned product to the combustion process by feeding into the engine air intake prior to the turbo compressor (if present). The latter has led to the requirement for a pressure control device to isolate the engine crankcase from air intake pressure. The engine test methods presented in ISO 17536 are general guidelines for performing an engine test. Annexes A to I specify general and common provisions for aerosol separator performance test. © ISO 2015 – All rights reserved

Scope: This part of ISO 17536 specifies general conditions, defines terms and establishes the basic principles for blowby oil aerosol separator performance tests by laboratory or engine and gravimetric or fractional test method. 2 Terms, definitions, symbols and units 2.1 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1.1 blowby aerosol produced from engines and released through a crankcase vent 2.1.2 oil carryover total amount of liquid oil captured in the downstream wall flow trap 2.1.3 filter element replaceable part of the crankcase system, consisting of the filter material and carrying frame 2.1.4 crankcase ventilation system device which separates oil and particles from the engine blowby before venting to either the engine (closed crankcase ventilation, CCV) or the environment (open crankcase ventilation, OCV) 2.1.5 differential pressure difference in static pressure measured immediately upstream and downstream of the unit under test 2.1.6 pressure loss measure of the loss of aerodynamic energy caused by an aerosol separator at the observed air flow rate due to different flow velocities at the measuring point. Note 1 to entry: It is expressed as the differential pressure corrected for any difference in the dynamic head at the measuring points Note 2 to entry: For further information, see Annex A. 2.1.7 wall flow trap device to capture oil that is flowing along the walls Note 1 to entry: The wall flow trap design is drawn in Figure I.2. INTERNATIONAL STANDARD ISO 17536-1:2015(E) © ISO 2015 – All rights reserved

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17536-1-2015 PDF

ISO 17536-1-2015 PDF

$13.00 $26.00