Welding consumables — Tubular cored electrodes and rods for gas shielded and non-gas shielded metal arc welding of stainless and heat-resisting steels — Classification
Introduction: This document provides a classification system for tubular cored electrodes and rods for welding stainless and heat resisting steels. It recognizes that there are two somewhat different approaches in the global market to classifying a given tubular stainless steel welding consumable, and allows for either or both to be used, to suit a particular market need. Application of either type of classification designation (or of both, where suitable) identifies a product as classified in accordance with this document. The classification in accordance with system A was mainly based on EN 12073:1999 which has been withdrawn and replaced by this standard. The classification in accordance with system B is mainly based upon standards used around the Pacific Rim. © ISO 2025 – All rights reserved
Scope: This document specifies requirements for classification of tubular flux and metal cored electrodes and rods, based on the all-weld metal chemical composition, the type of core, shielding gas, welding position and the all-weld metal mechanical properties, in the as-welded or heat-treated conditions, for gas shielded and non- gas shielded metal arc welding of stainless and heat-resisting steels. This document is a combined standard providing for classification utilizing a system based upon nominal composition or utilizing a system based upon alloy type. a) Clauses, subclauses, and tables which carry the suffix “System A” are applicable only to products classified using the system based upon nominal composition. b) Clauses, subclauses, and tables which carry the suffix “System B” are applicable only to products classified using the system based upon alloy type. c) Clauses, subclauses, and tables which do not have either the suffix “System A” or “System B” are applicable to all products classified in accordance with this document. This document does not use pulsed current for determining the product classification, neither does it address ferrite numbers (see Annex D and ISO/TR 22824).