Water quality - Determination of available free cyanide (pH 6) using flow injection analysis (FIA), gas-diffusion and amperometric detection
Introduction: Methods using flow analysis automate wet chemical procedures and are particularly suitable for the determination of many analytes in water in large sample series at a high analysis frequency. Analyses can be performed by flow injection analysis (FIA) using the feature of an automatic dosage of the sample into a flow system (manifold) where the analytes in the sample reacts with the reagent solutions on their way through the manifold. The sample preparation can be integrated in the manifold. The reaction product is measured by a flow detector (e.g. amperometer). © ISO 2015 – All rights reserved
Scope: This International Standard specifies methods for the determination of available free cyanide at pH 6 in various types of water (such as ground, drinking, surface, leachate, waste water, and metallurgical processing waste water) with cyanide concentrations from 5 µg/l to 500 µg/l expressed as cyanide ions in the undiluted sample. The range of application can be changed by varying the operation conditions, e.g. by using a different injection volume (Figure A.1). NOTE 1 ISO 2080:2008, 3.105, the concentration of available free cyanide as determined by a specified analytical method. NOTE 2 The detection limit for this method was determined by interlaboratory testing at the national level using ASTM International D6512 Practice for Interlaboratory Quantitation Estimate. NOTE 3 Free cyanides according to ISO 14403 and ISO 17690 are not equivalent. In this method, two suitable mass concentration ranges from 5 µg/l to 50 µg/l and from 50 µg/l to 500 µg/l are described.