Thermal insulation products — Exterior insulation and finish systems (EIFS) — Part 3: Design requirements
Introduction: This document provides specifications for architects, design professionals and builders on the integration of an exterior insulation and finish system (EIFS) into their projects. This document is predicated on the selected EIFS assembly being in compliance with the requirements of ISO 17738-1, and system installation in compliance with ISO 17738-2. The design criteria in this document are based on the principle that the building envelope contains five ‘planes-of-control’: — water-shedding barrier; — water-resistive barrier; — thermal barrier; — air barrier; — vapour barrier. Each plane-of-control corresponds to an individual function that the cladding assembly is designed to perform. The function of the planes-of-control are: — Water-shedding barrier: This is designed to deflect rainwater away from the wall surface, thereby minimizing water penetration into the cladding assembly. — Water resistive barrier: Accepting that some water could find its way behind the cladding, a continuous water resistive barrier is required to protect the substrate. Water that penetrates one cladding component should not be directed to drain behind another. Any water that reaches the water resistive barrier should have a clear drainage path to the exterior of the cladding. — Continuous thermal barrier: The principle benefit of an EIFS cladding is the continuous thermal barrier installed on the exterior of the structure. Insulation should be adequate to prevent condensation within the wall assembly
Scope: This document specifies the design requirements, selection and application of exterior insulation and finish systems (EIFS) for use by building designers, building code officials, product manufacturers and contractors in order to sustain the installed performance and durability of EIFS. NOTE This document does not address all aspects related to EIFS design, selection and use. A working knowledge of applicable regional building codes and regulations is helpful when working with this document. There could be other considerations for specific installations that are not addressed by this document. This document contains design requirements for the design and installation of an EIFS as a wall cladding system. The document includes selection of materials that meet the requirements of ISO 17738-1, and installation requirements in accordance with ISO 17738-2 and covers the interfaces between EIFS and other building assemblies and components. This document refers to adhesively fastened systems, although mechanical fastening could be required in specific circumstances (refer to Annex A). For information on EIFS resiliency, refer to Annex B. This document does not specify the structural design of the substrate to which the EIFS is attached, nor does it provide design requirements when the installation of EIFS uses mechanical fasteners. This document is applicable to new and retrofit EIFS installations.