Biocombustibles solides - Détermination de la distribution granulométrique des combustibles non comprimés - Partie 1: Méthode au tamis oscillant d’ouverture de maille égale ou supérieure à 3,15 mm
Introduction: Particle size and size distribution of uncompressed solid biofuels significantly influence the transport, handling and combustion properties of solid fuels. Depending on the type of fuel feeding and the type and size of a conversion plant, fuels of different particle sizes are suitable. Of particular interest are also the fines fraction and oversized particles. An increased content of fine particles can lead to clogging in feed systems and unsteady combustion. Oversized particles can block conveying systems or cause bridging problems in silos and can reduce the bulk density of the fuel. Very fine particles can have negative health effects and are relevant for explosion protection reasons (< 0,5 mm). The ISO 17827 series, describing the determination of particle size distribution, consists of the following parts under the general title Solid biofuels — Determination of particle size distribution for uncompressed fuels: Part 1: Oscillating screen method using sieves with apertures of 3,15 mm and above Part 2: Vibrating screen method using sieves with apertures of 3,15 mm and below © ISO 2024 – All rights reserved
Scope: This document specifies a method for the determination of the size distribution of particulate biofuels by the horizontally oscillating screen method. It applies to particulate uncompressed fuels with a nominal top size of 3,15 mm and above, e.g. wood chips, hog fuel, olive stones. The method is intended to characterize material up to a particle size class (P) of P63. For larger P-classes and PL-classes, the characterization is mainly done by hand sorting. NOTE The definitions and specifications of P- and PL-classes are given in ISO 17225-1, ISO 17225-4 and ISO 17225-9.