ISO 17828-2025 PDF

ISO 17828-2025 PDF

Solid biofuels-Determination of bulk density

$60.00 $120.00 -50%
Product Code: ISO 17828
Stock In Stock
Edition: 2.
Published: 03/2025
Number of Pages: 18
File Size: 1 file, 1 Byte

Available Options

Product Description

Biocombustibles solides - Détermination de la masse volumique apparente

Introduction: Bulk density is an important parameter for fuel deliveries on volume basis, and together with the net calorific value, it determines the energy density. It also facilitates the estimation of space requirements for transport and storage. This document describes the determination of the bulk density of pourable solid biofuels which can be conveyed in a continuous material flow. For practical reasons, containers with different volumes are applied: — standardized container of 5 l, e.g. for pellets, shavings, sawdust or grain kernels; — standardized container of 50 l, for materials with a nominal top size of up to 63 mm; — non-standardized container of more than 1 m3 volume, for coarse bulk material with larger particle sizes. The actual storage volume of a solid biofuel depends on the storage conditions, which can differ markedly from the conditions of sample analysis (e.g. height of heap versus volume of the standard measuring container, moisture content). The described method using the standardized containers includes a defined shock exposure of the bulk material for several reasons. A shock leads to a certain volume reduction, which accounts for compaction effects occurring during the production chain. These compaction effects are mainly due to the fact that the fuel is usually transported and/or stored in containers or silos that are much larger than the measuring container as chosen for the described method. Thus, in practice, the higher mass load leads to an increased load

Scope: This document specifies a method for determining the bulk density of solid biofuels using a standardized measuring container. This method is applicable to all pourable solid biofuels with a nominal top size of maximum 63 mm while the maximum particle length is 200 mm. For fuels with a nominal top size larger than 63 mm, a different method is described. Bulk density is not an absolute value; therefore, conditions for its determination have to be standardized in order to gain comparative measuring results. NOTE Bulk density of solid biofuels is subject to variation due to several factors such as vibration, shock, pressure, biodegradation, drying, and wetting. Measured bulk density can therefore deviate from actual conditions during transportation, storage, or transhipment.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17828-2025 PDF

ISO 17828-2025 PDF

$60.00 $120.00