ISO 17892-10-2018 PDF

ISO 17892-10-2018 PDF

Geotechnical investigation and testing - Laboratory testing of soil - Part 10: Direct shear tests

$96.50 $193.00 -50%
Product Code: ISO 17892-10
Stock In Stock
Edition: 1ST
Published: 11/2018
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Geotechnical investigation and testing - Laboratory testing of soil - Part 10: Direct shear tests

Introduction: This document provides laboratory test methods for the determination of the effective shear strength of soils by direct shear within the international field of geotechnical engineering. The tests have not previously been standardized internationally. It is intended that this document presents broad good practice and significant differences with national documents are not anticipated. It is based on international practice (see Reference [1]). This document specifies two methods for the determination of the effective shear strength of soils under consolidated drained conditions using either a shearbox or a ring shear device. The shearbox test is generally used for the determination of peak effective shear strength parameters of soils. The ring shear test is generally used for the determination of residual effective shear strength parameters of fine grained soils. Residual effective shear strength parameters can also be obtained from shearbox tests and peak effective shear strength parameters can also be obtained from ring shear tests. The test method consists of placing the test specimen in the direct shear device, applying a pre- determined vertical stress, providing for draining (and wetting if required) of the test specimen, consolidating the specimen under vertical stress and then shearing the specimen. This shearing is imposed by displacing one part horizontally, relatively with respect to the other part of the specimen at a constant rate of shear-deformation. The shearing

Scope: This document specifies two laboratory test methods for the determination of the effective shear strength of soils under consolidated drained conditions using either a shearbox or a ring shear device. This document is applicable to the laboratory determination of effective shear strength parameters for soils in direct shear within the scope of geotechnical investigations. The tests included in this document are for undisturbed, remoulded, re-compacted or reconstituted soils. The procedure describes the requirements of a determination of the shear resistance of a specimen under a single vertical (normal) stress. Generally three or more similar specimens from one soil are prepared for shearing under three or more different vertical pressures to allow the shear strength parameters to be determined in accordance with Annex B. Special procedures for preparation and testing the specimen, such as staged loading and pre-shearing or for interface tests between soils and other materials, are not covered in the procedure of this document. NOTE This document fulfils the requirements of the determination of the drained shear strength of soils in direct shear for geotechnical investigation and testing in accordance with EN 1997-1 and EN 1997-2.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17892-10-2018 PDF

ISO 17892-10-2018 PDF

$96.50 $193.00