ISO 17892-12-2018 PDF

ISO 17892-12-2018 PDF

Geotechnical investigation and testing - Laboratory testing of soil - Part 12: Determination of liquid and plastic limits

$13.00 $26.00 -50%
Product Code: ISO 17892-12
Stock In Stock
Edition: 1ST
Published: 06/2018
Number of Pages: 34
File Size: 1 file, 1 Byte

Available Options

Product Description

Geotechnical investigation and testing - Laboratory testing of soil - Part 12: Determination of liquid and plastic limits

Introduction: This document covers areas in the international field of geotechnical engineering never previously standardised internationally. It is intended that this document presents broad good practice and significant differences with national documents is not anticipated. It is based on international practice (see Reference [1]). © ISO 2018 – All rights reserved

Scope: This document specifies methods for the determination of the liquid and plastic limits of a soil. These comprise two of the Atterberg limits for soils. The liquid limit is the water content at which a soil changes from the liquid to the plastic state. This document describes the determination of the liquid limit of a specimen of natural soil, or of a specimen of soil from which material larger than about 0,4 mm has been removed. This document describes two methods: the fall cone method and the Casagrande method. NOTE The fall cone method in this document should not be confused with that of ISO 17892-6. The plastic limit of a soil is the water content at which a soil ceases to be plastic when dried further. The determination of the plastic limit is normally made in conjunction with the determination of the liquid limit. It is recognized that the results of the test are subject to the judgement of the operator, and that some variability in results will occur.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17892-12-2018 PDF

ISO 17892-12-2018 PDF

$13.00 $26.00