Road vehicles — Local Interconnect Network (LIN) — Part 2: Transport protocol and network layer services
Introduction: The LIN protocol as proposed is an automotive focused low speed universal asynchronous receiver transmitter (UART) based network. Some of the key characteristics of the LIN protocol are signal based communication, schedule table-based frame transfer, commander/responder communication with error detection, node configuration and diagnostic service transportation. The LIN protocol is for low-cost automotive control applications as, for example, door module and air conditioning systems. It serves as a communication infrastructure for low-speed control applications in vehicles by providing: — signal based communication to exchange information between applications in different nodes; — bitrate support from 1 kbit/s to 20 kbit/s; — deterministic schedule table-based frame communication; — network management that wakes up and puts the LIN cluster into sleep mode in a controlled manner; — status management that provides error handling and error signalling; — transport layer that allows large amount of data to be transported (such as diagnostic services); — specification of how to handle diagnostic services; — electrical physical layer specifications; — node description language describing properties of responder nodes; — network description file describing behaviour of communication; — application programming interface. The ISO 17987 series is based on the open systems interconnection (OSI) basic reference model as specified in ISO/IEC 7498-1 which structures communication systems in
Scope: This document specifies a transport protocol and network layer services tailored to meet the requirements of LIN‑based vehicle network systems on local interconnect networks. The protocol specifies an unconfirmed communication. The LIN protocol supports the standardized service primitive interface as specified in ISO 14229-2. This document provides the transport protocol and network layer services to support different application layer implementations such as: — normal communication messages, and — diagnostic communication messages. The transport layer defines transportation of data that is contained in one or more frames. The transport layer messages are transported by diagnostic frames. A standardized API is specified for the transport layer. Use of the transport layer is targeting systems where diagnostics are performed on the backbone bus (e.g. CAN) and where the system builder wants to use the same diagnostic capabilities on the LIN sub-bus clusters. The messages are in fact identical to ones in ISO 15765-2 and the PDUs carrying the messages are very similar. The goals of the transport layer are: — to have low load on commander node, — to provide full (or a subset thereof) diagnostics directly on the responder nodes, and — to target clusters built with powerful LIN nodes (not the mainstream low cost). A typical system configuration is shown in Figure 1. © ISO 2025 – All rights reserved ISO 17987-2:2025(en) Figure 1 — Typical system setup for a LIN cluster using the transport layer 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO/IEC 7498-1, Information technology — Open Systems Interconnection — Basic Reference Model: The Basic Model ISO 14229-1, Road vehicles — Unified diagnostic services (UDS) — Part 1: Application layer ISO 14229-2, Road vehicles — Unified diagnostic services (UDS) — Part 2: Session layer services ISO 14229-7, Road vehicles — Unified diagnostic services (UDS) —