Road vehicles — Local Interconnect Network (LIN) — Part 6: Protocol conformance test specification
Introduction: The LIN protocol as proposed is an automotive focused low speed universal asynchronous receiver transmitter (UART) based network. Some of the key characteristics of the LIN protocol are signal-based communication, schedule table-based frame transfer, commander/responder communication with error detection, node configuration and diagnostic service transportation. The LIN protocol is for low-cost automotive control applications as, for example, door module and air conditioning systems. It serves as a communication infrastructure for low-speed control applications in vehicles by providing: — signal-based communication to exchange information between applications in different nodes; — bit rate support from 1 kbit/s to 20 kbit/s; — deterministic schedule table-based frame communication; — network management that wakes up and puts the LIN cluster into sleep state in a controlled manner; — status management that provides error handling and error signalling; — transport layer that allows large amount of data to be transported (such as diagnostic services); — specification of how to handle diagnostic services; — electrical physical layer specifications; — node description language describing properties of responder nodes; — network description file describing behaviour of communication; — application programming interface. The ISO 17987 series is based on the open systems interconnection (OSI) basic reference model as specified in ISO/IEC 7498-1 which structures communication systems
Scope: This document specifies the LIN protocol conformance test. This test verifies the conformance of LIN communication controllers with respect to ISO 17987-2 and ISO 17987-3. This document provides all necessary technical information to ensure that test results are identical even on different test systems, provided that the particular test suite and the test system are compliant to the content of this document. Annex A, Annex B and Annex C specify the protocol conformance test plans for responder nodes supporting auto addressing procedures according procedure C, procedure D or procedure E, see ISO 17987-3:2025, Annex C.