Rubber hose and hose assemblies for oil suction and discharge service - Specification
Introduction: This International Standard specifies minimum requirements for the satisfactory performance of wire- or textile-reinforced rubber hose assemblies of both smooth and rough bore types for oil suction and discharge services. The hoses are commonly used for transferring crude oil and liquid petroleum products, other than liquefied petroleum gas and natural gas, to and from tanker and bunkering vessels or for similar duties ashore. Specific details of the construction of hoses are not rigidly defined in this International Standard since it is felt that this could restrict the introduction of improved methods of construction. The hose assemblies have been classified and designated in terms of service pressure, which includes an allowance for surge pressure and which equates to the factory test pressure. To keep this specification in line with other documents, this factory test pressure is also defined as the maximum working pressure (see Table 1). It is the responsibility of the user to determine the appropriate working pressure, which will depend on the severity of the user’s operating conditions and on the service life that is expected of the hose assembly. It is necessary for the purchaser to provide certain information about the hose assembly and its intended use at the time of enquiry and/or order; this information is listed in Annex A (informative). Recommendations concerning packaging and transportation are given in Annex B (informative) and expected masses of hoses, in kilo
Scope: This International Standard specifies the characteristics of four types of oil suction and discharge hose assemblies used for the conveyance of petroleum, including crude oils and other liquid petroleum products. Each type being divided into three classes depend on the aromatic contents. It is not suitable for liquefied petroleum gas and natural gas. Hose assemblies to this International Standard can be used in the temperature range −20 °C to 80 °C. The hoses specified are in the range of nominal size 50 to 500 and can be types of smooth bore, rough bore, armoured rough bore, and light weight.