Brazing Imperfections in brazed joints
Introduction: Brazed joints usually contain imperfections of various types, some of which are detrimental in almost every case while others can be detrimental or harmless, depending entirely on the service requirements of the joint in question. Therefore, it is often necessary to classify the imperfections in a brazed joint and then try to assess the significance of their effects on the behaviour of the joint in service. The classification is relatively easy and Table 1 describes the imperfections that most commonly occur. The assessment of significance is not easy (see also Annex A). For welded joints, there has been extensive work carried out for many years on the significance of imperfections in service; however, such work has not been carried out on brazed joints. Moreover, the work on welded joints is only rarely relevant to brazed joints, mainly because of differences in geometry and stressing. Therefore, this document cannot give definitive quality levels for brazed joints. These can only be produced as experience is gained from industrial applications. However, Annex B gives some suggestions for quality levels for general applications, which can be of help where detailed information is not available. The use of quality levels can only be successful if the imperfections that are relevant to the application of the brazed joint are determined. © ISO 2023 – All rights reserved
Scope: This document details a classification of imperfections that can occur in brazing joints. In addition, guidance is provided on quality levels and suggested limits for imperfections are detailed. For requirements not covered by this document, reference can be made to other sources, such as statutory regulations, codes of practice and technical delivery conditions. No information is given on how imperfections are to be assessed in individual cases because this depends on the requirements for the particular brazed joint. These imperfections are not always detectable by the use of non-destructive testing alone. This document covers only imperfections that can occur in connection with brazing without the effect of any additional service loads. Only the type, shape and position of such imperfections are covered; no indication is given of the conditions of occurrence or causes. For requirements for brazed joints which are relevant and essential to the particular function of the component, reference can be made to the relevant documentation, for example manufacturing documents or procedure sheets. It is important that these requirements be precisely prescribed and that conformity with them be verifiable. Conformity can be established by testing either the brazed assembly itself or a test piece produced under comparable conditions. This document does not specify requirements for acceptance levels for imperfections, since these will differ very markedly depending on the application, but it does suggest some quality levels which can be of value in the absence of more detailed information. For the purposes of this document, the areas of a brazed assembly are designated as shown schematically in Figure 1. a) Simple brazed assembly © ISO 2023 – All rights reserved ISO 18279:2023(E) b) Section through assembly in a) Key parent material parent material affected by brazing [heat-affected zone (HAZ)] diffusion-transition zone braze metal NOTE Extent of HAZ will vary with materials and brazing process. Figure 1 — Schematic of brazed assembly 2 Normative references There are no normative references in this document. 3 Terms and definitions For the purposes of this document, the fol