Coal and coke — Manual sampling
Introduction: Mechanical sampling from moving streams is the preferred method for sampling coal and coke. However, often mechanical facilities are not available. Moreover, for sized coal or coke, mechanical sampling may be a problem because of (size) degradation by the sampling system. The fundamental requirements of sampling are that all particles of the coal or coke in the lot are accessible to the sampling instrument and thus have a non-zero chance of being selected, and that each individual particle of equal mass has an equal probability of being selected and included in the sample. When sampling manually, conditions are often far from ideal. The methods described in this document are intended to obtain the most representative sample that can be safely achieved. Manual sampling should only be applied if no possibility for mechanical sampling exists. The purpose of taking and preparing a sample of coal or coke is to provide a test sample that, when analysed, provides test results representative of the lot or sub-lot sampled. The first stage of sampling, known as primary sampling, is the taking from positions distributed over the entire lot of an adequate number of coal or coke portions known as primary increments. The primary increments are then combined into a sample. From this sample, the required number and types of test samples are prepared by a series of processes jointly known as sample preparation. In devising a sampling procedure, it is also essential to guard against bias in th
Scope: This document provides the basic terms used in manual sampling of coal and coke and describes the general principles of sampling. It provides procedures and requirements for establishing a manual sampling scheme, methods of manual sampling, sampling equipment, handling and storage of samples, sample preparation and a sampling report, and applies to manual sampling during the transfer of coal or coke. Guidelines for manual sampling in stationary situations are given in Annex B, but this method of sampling does not provide a representative test sample and the sampling report shall state this. This document covers sampling of brown coals and lignites, but does not include sampling from coal seams, for which guidance is given in ISO 14180. Mechanical sampling of coal and coke is covered in ISO 13909.