Aerospace — Linear hydraulic utility actuator — General specifications
Introduction: Linear hydraulic utility actuators are designed to move structural elements of a flight vehicle from one position to another to allow the functioning of various flight vehicle systems, such as landing gear, cargo doors, in-flight refuelling probes, etc. It is noted that, while ISO standards should normally refer only to SI units, large segments of the aerospace industry refer to other measurement systems as a matter of common working practice. All dimensions used in this document are in SI units with the non-SI units given in addition for the convenience of those users more familiar with these. It is further noted that the standard ISO decimal symbol “,” (comma) is not used as common working practice for inch dimensions. A decimal point is used in the inch dimensions in this document as in many other aerospace standards. NOTE The use of non-SI units and the decimal point in this document does not constitute general acceptance of measurement systems other than SI within International Standards. © ISO 2019 – All rights reserved
Scope: This document establishes the general requirements for a linear hydraulic utility actuator, herein referred to as a "utility actuator", for use in flight vehicle hydraulic systems at pressures up to 35 000 kPa (5 000 psi). These requirements include: — design requirements; — test requirements. This document is intended to be used in conjunction with the detail specification that is particular to each application. NOTE Although Brake pistons and Landing Gear Bogie (Truck) Pitch Trimmers are utility actuators, they are outside the scope of this document. This is because these devices are considered to be specialist actuator devices due to their specific duty cycles requiring a separate set of tailored requirements.