ISO 18418-1-2026 PDF

ISO 18418-1-2026 PDF

Gasoline engines-High pressure liquid fuel supply connections-Part 1: 60° concave cone connectors

$31.50 $63.00 -50%
Product Code: ISO 18418-1
Stock In Stock
Edition: 3.
Published: 01/2026
Number of Pages: 12
File Size: 1 file, 350 KB

Available Options

Product Description

Gasoline engines — High pressure liquid fuel supply connections — Part 1: 60° concave cone connectors

Introduction: Some spark ignition (SI) engines use direct injection (DI) fuel systems which supply gasoline under pressure from a high-pressure fuel pump to a rail via pipe assemblies with a 60° concave cone connector. Such components are similar to ISO 2974 and ISO 13296 for the diesel injection systems, except for the relationship between the outside and inside diameters of the pipes due to the lower pressure range. Connectors defined either in ISO 2974 or in this document can be used. GDI fuel systems typically operate in a pressure range of around 35 MPa and are labelled “high pressure”. In the context of all injections systems, including diesel, this same pressure range is considered as medium pressure, as diesel injection operates at much higher pressures, however the term “high pressure” is used in this document. © ISO 2026 – All rights reserved

Scope: This document specifies the dimensional requirements of high-pressure liquid fuel pipe end-connections for gasoline (spark ignition) engine fuel injection equipment. It is applicable to externally threaded end-connections having a 60° concave cone (see Figure 1), as well as to the pipe end assemblies of high-pressure fuel injection pipes with outside diameters of up to and including 10 mm (see Table 1).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 18418-1-2026 PDF

ISO 18418-1-2026 PDF

$31.50 $63.00