ISO 18488-2025 PDF

ISO 18488-2025 PDF

Polyethylene (PE) materials for piping systems-Determination of strain hardening modulus in relation to slow crack growth-Test method

$48.00 $96.00 -50%
Product Code: ISO 18488
Stock In Stock
Edition: 2.
Published: 10/2025
Number of Pages: 18
File Size: 1 file, 1 Byte

Available Options

Product Description

Polyethylene (PE) materials for piping systems — Determination of strain hardening modulus in relation to slow crack growth — Test method

Introduction: Resistance to slow crack growth of polyethylene materials is related in general to the lifetime of the material and thus, the lifetime of polyethylene products, e.g. pipes and fittings. The slow crack growth behaviour of a polyethylene material can be regarded as a combination of resistance to deformation of the crystalline phase (manifested as yield stress) and the amorphous phase (entangled chains and tie molecules) as reported by Kramer and Brown.[2],[3],[5],[6] The resistance to disentanglement of polymer chains in the amorphous phase of a polymer structure upon application of constant load will determine its resistance against slow crack growth. The strain hardening modulus of polyethylene material is a measure of the resistance to disentanglement of the entangled chains and tie molecules of this polymer and is an intrinsic property. The strain hardening modulus of polyethylene is obtained from a “true stress vs. draw ratio” curve above the natural draw ratio. The “true stress vs. draw ratio” curve of a compression moulded sheet is relatively easily obtained using a tensile test apparatus equipped with an appropriate extensometer. The test time for measuring the strain hardening modulus is a consequence of the speed of tensile testing and is therefore constant for all measurements and independent of the slow crack growth property of the tested material itself. The strain hardening modulus value allows differentiation between polyethylene materials. It has been demonstrat

Scope: This document specifies a method for the determination of the strain hardening modulus, which is used as a measure for the resistance to slow crack growth of polyethylene. This document specifies how to obtain a strain hardening modulus measurement from “true stress vs. draw ratio” curves on compression moulded samples. Details of the necessary equipment, precision and sample preparation for the generation of data are given. This document provides a method that is valid for all types of polyethylene, independent from the manufacturing technology, comonomer or catalyst type used for pipes and fittings applications.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 18488-2025 PDF

ISO 18488-2025 PDF

$48.00 $96.00