ISO 18535-2016 PDF

ISO 18535-2016 PDF

Diamond-like carbon films - Determination of friction and wear characteristics of diamond-like carbon films by ball-on-disc method

$48.00 $96.00 -50%
Product Code: ISO 18535
Stock In Stock
Edition: 1ST
Published: 03/15/2016
Number of Pages: 20
File Size: 1 file, 422 Bytes

Available Options

Product Description

Diamond-like carbon films - Determination of friction and wear characteristics of diamond-like carbon films by ball-on-disc method

Introduction: This International Standard gives guidance on conducting a sliding friction and wear test in a ball-on- disc configuration to determine the friction generated and wear observed in uniaxial sliding contacts between diamond-like carbon (DLC) films and a counter body. The tribological properties of DLC films are different from those of metallic and ceramic coatings. DLC films have the tribological characteristics of low friction and low wear against other materials. Since a DLC film is a coating, rather than a bulk material, it has a limited amount of wear and possibility of delamination. Hence, a friction and wear testing method specific to DLC films is used to determine friction and wear resistance independent of delamination. In the ball-on-disk method using a DLC- coated ball on a non-coated disk, a non-coated ball on a DLC-coated disk, or a DLC-coated ball on a DLC- coated disk, the wear of DLC is minimal compared with other materials; for this reason, it is preferable to apply the coating on the ball to measure the wear rate with a reasonable accuracy. Of course, the wear on the ball side induces a decrease in contact pressure that must be taken into account for the friction coefficient interpretation. Because of these aspects, the ball-on-disk method is ideal for conventional testing of DLC coatings. It should be noted that there are many parameters in the sliding contact that affect the magnitude of friction and wear. The aim of performing any wear test is to simulate, a

Scope: This International Standard specifies a procedure for and provides guidance on the determination of the coefficient of friction and the specific wear rate of diamond-like carbon (DLC) films. The method specifies that the materials are tested under dry conditions in pairs in a ball-on-disc configuration. The results of the tests are not applicable when DLC-coated parts operate in a lubricated environment.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 18535-2016 PDF

ISO 18535-2016 PDF

$48.00 $96.00