ISO 18566-3-2017 PDF

ISO 18566-3-2017 PDF

Building environment design - Design, test methods and control of hydronic radiant heating and cooling panel systems - Part 3: Design of ceiling mounted radiant panels

$71.50 $143.00 -50%
Product Code: ISO 18566-3
Stock In Stock
Edition: 1ST
Published: 06/2017
Number of Pages: 22
File Size: 1 file, 905 Bytes

Available Options

Product Description

Building environment design - Design, test methods and control of hydronic radiant heating and cooling panel systems - Part 3: Design of ceiling mounted radiant panels

Introduction: There are various types of hydronic radiant heating and cooling systems: ceiling mounted radiant panels, chilled beams, pipe embedded ceilings, walls, and floors. In those system alternatives, ceiling mounted radiant panels are widely used and frequently installed on T-bar grids designed to support the dropped acoustical ceiling. The ceiling mounted radiant panels are top loaded with thermal insulation to prevent heat gain from or loss to the plenum space. In some cases, free hanging metal panels suspended under the room ceiling by wire hangers without topside insulation are also used for space heating and cooling. Both top and bottom surfaces of the free-hanging metal panel are used as heat transfer surfaces. In principle, ceiling mounted radiant panel systems are able to accommodate varying space sensible loads by controlling panel surface temperature. Heat is transferred from the radiant panel by the heat transfer mechanisms of convection and radiation. Generally, low temperature radiant heating and high temperature radiant cooling are classified as embedded radiant heating and cooling systems and ceiling mounted radiant panel systems. While ISO 11855 is for embedded radiant heating and cooling systems without an open air gap, ISO 18566 is for radiant heating and cooling panel systems with an open air gap. Because the system specifications for ISO 18566 are different from those of ISO 11855, it was necessary to develop separate ISO standards regarding the design and test m

Scope: This document specifies the design of ceiling mounted radiant panels. This document is applicable to water-based heating and cooling panel systems (free hanging) in residential, commercial and industrial buildings. The methods apply to systems mounted to the ceiling construction with an open air gap. This document applies to all types of prefabricated radiant panels that are part of the room periphery. This document does not cover panels embedded into ceiling, wall or floor structures without open air gap and hybrid (combined thermal radiation and forced-convection) ceiling panels.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 18566-3-2017 PDF

ISO 18566-3-2017 PDF

$71.50 $143.00