Determination of particle density by sedimentation methods - Part 2: Multi-velocity approach
Introduction: Dispersions are widely used in industry and everyday life. There is a need to understand the density of dispersed particles or droplets, e.g. for physico-chemical calculations such as kinematic viscosity of dispersions[1], determination of particle size distribution by sedimentation[2][3] or acoustic techniques[4], particle characterization by field-flow approaches[5], optimization of dispersion long- term stability by density matching[6] as well as, more generally, characterization of particles (e.g. composition, internal phase content of double emulsions or homogeneity of hollow capsules) in manifold academic and industrial areas. Nowadays there is an increasing interest in using particle density to estimate the mass transfer of nanoparticles atop cell layers by sedimentation (dosage calculation for in vitro nanotoxicity assessment[7][8][9]). The density of a body is defined as its mass divided by its volume. This calculation is straightforward for a large uniform body or particle. However, determination of the volume of a macroscopic body is difficult. The geometrical volume (defined by length, width and thickness) and the volume relevant for the determination of density may differ due to surface irregularities, fractures, fissures and pores or the measuring techniques employed. Density determination of micro-particles, especially nanoparticles dispersed in a liquid, is difficult not only due to the determination of mass and volume for small particles, but also due to the
Scope: This document specifies an in situ method for the determination of the density of solid particles or liquid droplets (herein referred to as “particle”) dispersed in liquid continuous phase. The method is based on direct experimental determination of particle velocity in these liquids or media in gravitational or centrifugal fields based on Stokes law. The particle density is calculated from experimentally determined particle velocities in different liquids or media, taking into account their dynamic viscosities and densities, respectively. The approach does not require the knowledge of particle size distribution but assumes that sedimentation relevant characteristics (e.g. volume, shape, agglomeration state) do not change. This document does not consider polydispersity with regard to particle density, i.e. all particles are assumed to be of the same material composition.