Biocombustibles solides - Détermination de la masse volumique unitaire des granulés et des briquettes
Introduction: Particle density is a fuel parameter of pellets and briquettes which is often considered when describing the degree of compaction of the raw material used. Particle density can be highly specific for the respective type or species of biomass and thus, it also characterizes the material's general ability to be compacted. High particle density is often associated with high resistance to abrasion or low susceptibility towards fracturing during handling and storage. A high particle density also generally leads to reduced storage volume demands and to a lower filling level in a combustion chamber at constant fuel mass flow. Particle density can also affect the heat transfer rate within the fuel and thus, it can have an impact on fuel ignition and on the dynamics of gasification. Apart from the buoyancy method which is described in this document as a reference method, larger particles (briquettes) are sometimes easier tested by simple stereometric means. For internal laboratory practices, such a procedure is also presented in Annex A. For small particles (pellets), this procedure is not recommended. For pellets, a simplified method using the displacement of a liquid by the pellets is available, which can be used as an on-site method, and is described in Annex B. Pellets disintegrate in water relatively fast, but with the buoyancy method the particle density is sufficiently stable for about 30 s (see [3]). To improve reproducibility, the reading of the results is fixed at 5 s. This
Scope: This document specifies a method for determining the particle density of compressed fuels such as pellets or briquettes. Particle density is not an absolute value and conditions for its determination have to be standardized to enable comparative determinations to be made.