ISO 18851-2015 PDF

ISO 18851-2015 PDF

Plastics piping systems - Glassreinforced thermosetting plastics (GRP) pipes and fittings - Test method to prove the structural design of fittings

$48.00 $96.00 -50%
Product Code: ISO 18851
Stock In Stock
Edition: 1ST
Published: 03/15/2015
Number of Pages: 12
File Size: 1 file, 339 Bytes

Available Options

Product Description

Plastics piping systems - Glassreinforced thermosetting plastics (GRP) pipes and fittings - Test method to prove the structural design of fittings

Scope: This International Standard specifies methods of test for fittings of any form, i.e. bends, branches, tapers, intended to be used in plastics piping systems for pressure and non-pressure drainage and sewerage or water supply made of glass-reinforced thermosetting plastics (GRP). This International Standard is applicable to fittings, in order to test their structural design, but is not applicable to connecting joint systems. It assumes that the fitting either is or is not intended to be subject to the effects of hydrostatic end thrust. The tests detailed in 8.1 to 8.4 are applicable to fittings intended to be used in buried or non-buried applications. These test procedures are applicable to fittings of all nominal sizes specified in the referring standard. The tests are for evaluating fittings intended for use in applications conveying liquids at temperatures specified in the referring standards. The test procedures in this International Standard are damaging to the test piece which will not be suitable for reuse after these tests. The test procedure is applicable to type testing. NOTE This International Standard is not intended to be used for the assessment of the performance of non- integrated joints as there are already international test methods for this purpose. See Bibliography. 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 pressure hydrostatic gauge pressure 3 Principle A fitting is subjected to a specified internal pressure with or without end thrust. The procedure includes prolonged static tests at elevated pressures. At the end of each of the tests, the test piece is inspected for signs of failure as defined in 8.2. It is assumed that the following test parameters are set by the standard making reference to this International Standard: a) number of test pieces to be used (see 5.2); b) if applicable, conditioning other than given in Clause 6; c) test temperature and its permissible deviations (see Clause 7); d) nominal pressure relevant to the fitting under test (see 5.1 and Clause 8); e) if applicable, any criteria indicative of structural damage to the fitting [see Clause 8 and Clause 9 i)]; f

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 18851-2015 PDF

ISO 18851-2015 PDF

$48.00 $96.00