Gas turbine combined cycle power plants - Thermal performance tests
Introduction: This document specifies standard rules for preparing, conducting, evaluating and reporting thermal performance tests in order to determine and/or verify the power output, the thermal efficiency (heat rate) and/or other performance test parameters for gas turbine driven combined cycle power plants. It provides information on methods of measurement considering uncertainties and on methods for corrected results obtained under test conditions in order to compare to guaranteed or specified conditions. The objective of testing conducted per this document is to determine combined cycle thermal performance characteristics in accordance with any previously drawn up agreements such as the purchase agreements, test criteria documents, engineering, procurement and construction (EPC) requirements, power purchase agreements, power and water purchase agreements, contractual services agreements. The document also provides guidelines for comparative tests designed to check performance differentials of the combined cycle and cogeneration power plants, for testing before and after modifications, upgrades or overhauls. Improvements to achieve additional performance of the combined cycle may include modification/substitutions of main components and additions of components inside test boundary. This comparative testing philosophy may also be used for “periodic testing” of the plant in order to monitor overall plant performance degradation, while giving due consideration to the relative testing unc
Scope: This document specifies standard rules for preparing, conducting, evaluating and reporting thermal performance tests on combined cycle and cogeneration power plants driven by gas turbines for base and part load operation with or without supplementary firing. This document is applicable to — thermal performance tests for general information, — thermal acceptance tests for determining the performance of the combined cycle plant in relation to a contractual guarantee, and — comparative tests designed to check the performance differentials of the combined cycle and cogeneration power plants, for testing before and after modifications, upgrades or overhauls. It can be used to determine the following thermal performance test goals and expected values, under specific operating and reference conditions within defined test boundaries: — electrical power output; — heat rate or thermal efficiency; — process steam and/or district heat w/o generation of electrical power output by means of a steam turbine. This document does not apply to individual equipment component testing, which is covered by corresponding standards. It is not intended to be applied to the following test goals: — environmental testing for example emissions, noise; — vibration testing; — operational testing; — absolute or comparative performance of specific components of the combined cycle covered by dedicated standards (e.g. gas turbines).