Imaging materials — Photographic reflection prints — Methods for measuring indoor light stability
Introduction: This document addresses the methods and procedures for measuring the indoor light stability of photographic reflection prints[3]–[5][11]–[16][20]. The length of time that such photographs are to be kept can vary from a few days to many hundreds of years and the importance of image stability can be correspondingly small or great. Often the ultimate use of a particular photograph may not be known at the outset. Knowledge of the lightfastness level of colour photographs is important to manufacturers to improve print materials and to many users, especially since stability requirements may vary depending upon the application. The images of most modern analogue and digitally-printed colour photographs are made up of cyan, magenta, yellow, red, green, blue, orange, black, grey, white or other colourants. Colour photographic images typically fade during storage and display; they will usually also change in colour balance because the various image colourants seldom fade at the same rate. In addition, a yellowish (or occasionally other colour) stain may form and physical degradation may occur, such as embrittlement and cracking of the support and image layers. The rate of fading and staining can vary appreciably and is governed principally by the intrinsic stability of the colour photographic material and by the conditions under which the photograph is stored and displayed. For silver halide prints, the quality of any chemical processing is another important factor. Post processing tre
Scope: This document describes test equipment and procedures for measuring the light stability of colour photographic reflection prints designed for display, when subjected to a filtered xenon-arc light source simulating daylight through windows at specified temperatures and relative humidity. This document is applicable to photographic reflection prints, made with analogue and digital print processes. The recommended test methods can be applied to both colour and black-and-white photographic prints. This test method assesses colour and density change.