Imaging materials — Scratch resistance of photographic prints — Part 1: General test method
Introduction: This document is one of a series ISO 189xx relating to permanence and durability of image prints, which is the resistance to mechanical, chemical and/or environmental stresses in conditions of use. The permanence of the image under environmental stresses is tested by each stress factor individually: light (ISO 18937[8]), heat (ISO 18936[7]), ozone (ISO 18941[9]), and humidity (ISO 18946[10]). These stress factors are given by the ambient conditions, over which the user often has limited control. The exposure to mechanical and physical stress may often be controlled by the user, unless intense handling is integral to intended use. Tests for rubbing of prints resulting in abrasion or smearing of the image are handled in ISO 18947 (all parts)[11], scratch resistance is addressed in ISO 18922[5] (for film) and durability tests to simulate accidental exposure to water are described ISO 18935[6]. Photographic prints are also susceptible to scratching when handled during their intended use. This problem is particularly evident with digital prints, which may have colorants on the surface without protection from physical damage. The test methods in this document for evaluating the scratch resistance of photographic prints provides another means of characterizing the physical durability of photographic prints. Scratching tends to occur in a specific location at a single point of contact, as opposed to abrasion which affect larger areas of the print material. And it might occur accident
Scope: This document specifies test method, test target, and reporting requirements to determine the scratch resistance of prints with photographic images. Photographic images can be produced by a wide range of printing technologies, including silver halide, electrophotography, inkjet, dye diffusion thermal transfer, commonly known as dye sublimation, and dye transfer processes. This document is applicable to prints with paper substrate and other type of substrates including prints on plastic, glass, metal and other materials. This document is applicable to photographic prints that have no protection as well as photographic prints that are protected by a coating or lamination. It is not the purpose of this document to define limits of acceptability or failure. They would be determined by the user and the intended application.