Railway applications — Suspension components — Rubber diaphragms for pneumatic suspension springs
Introduction: This document is based on EN 13597:2003. Designing a suspension diaphragm requires knowledge of the mechanical system of which it forms part. Specific characteristics are therefore needed for each case, which only the customer can specify. The requirements of this document are intended to be implemented in conjunction with the conditions for the supply of air spring suspension diaphragms. This document is the result of studies and research to improve the performance and quality of rubber diaphragms for pneumatic suspension springs in order to meet the requirements of railway rolling stock. This document is designed for involved parties such as railway operators, manufacturers and equipment suppliers of the railway industry as well as for suppliers of rubber diaphragms for pneumatic suspension springs. © ISO 2025 – All rights reserved
Scope: This document specifies the characteristics for suspension diaphragms to achieve, together with applicable inspection and test methods to be carried out for verification. An air spring system usually consists of a diaphragm (subject of this document) and additional components such as either emergency or additional springs, or both, and other assembly parts. This document does not detail the other components of air suspension or control systems such as air reservoirs, air piping, levelling system, frames, stiffeners, emergency suspension systems or elastic supports (such as series springs), etc., which will affect the diaphragm performance. This document applies to suspension diaphragms (inflated with air) designed to be fitted on railway vehicles and similar vehicles running on dedicated tracks with permanent guide systems, whatever the type of rail and the running surface. These parts are typically made with elastomer, textile fabrics and metallic beads.