ISO 18971-2026 PDF

ISO 18971-2026 PDF

Corrosion of metals and alloys-Monitoring method for corrosion states of stainless steel in industrial cooling water

$71.50 $143.00 -50%
Product Code: ISO 18971
Stock In Stock
Edition: 1.
Published: 01/2026
Number of Pages: 22
File Size: 1 file, 2.1 MB

Available Options

Product Description

Corrosion of metals and alloys — Monitoring method for corrosion states of stainless steel in industrial cooling water

Introduction: Cooling water is widely used in industrial production. In the industrial cooling water system, the use of stainless steel tubes in heat exchangers is very common. It generally accounts for over 60 %, but some countries have accounted for over 90 %. The corrosion of stainless steel in industrial cooling water is mainly localized corrosion dominated by pitting, which is invisible, fast-acting and difficult to prevent. When localized corrosion causes perforation in stainless steel, this can have disastrous consequences. The polarization resistance method is widely used to monitor the uniform corrosion rate of metals. This document describes the method of using polarization resistance and corrosion potential to monitor the corrosion states of stainless steel in industrial cooling water. It can be used to monitor the corrosion tendency of stainless steel. It can also be used to indicate the change of corrosiveness of cooling water (see Annex A). Protective measures can be taken in timely manner to prevent the occurrence of accidents caused by corrosion perforation of stainless steel tubes. © ISO 2026 – All rights reserved

Scope: This document specifies the method and criteria for monitoring corrosion states of heat exchange tubes, heat exchange plates and other components made of stainless steel in industrial cooling water by combination of polarization resistance and corrosion potential. This document is applicable to the monitoring of the corrosion states of stainless steel in industrial cooling water or similar media, as well as the monitoring of the corrosiveness of industrial cooling water. The cooling water is generally taken from natural water, tap water and reclaimed water. It is applicable to industrial cooling water with pH value of 5,0 to 11,0, temperature of 0 °C to 60 °C, and conductivity higher than 20 μS/ cm.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 18971-2026 PDF

ISO 18971-2026 PDF

$71.50 $143.00