ISO 19072-2-2019 PDF

ISO 19072-2-2019 PDF

Road vehicles-Connection interface for pyrotechnic devices, two-way and three-way connections-Part 2: Test methods and general performance requirements

$60.00 $120.00 -50%
Product Code: ISO 19072-2
Stock In Stock
Edition: 3.
Published: 12/2019
Number of Pages: 28
File Size: 1 file, 1 Byte

Available Options

Product Description

Véhicules routiers - Interface de raccordement pour dispositifs pyrotechniques, deux voies et trois voies - Partie 2: Méthodes d’essai et exigences des performances générales

Introduction: Road vehicles integrate an increasing number of pyrotechnic devices contributing to occupant safety in vehicles (for example, frontal and side air bags, safety belt pretensioner, etc.). To build the complete system providing the function requires a supply of various components from several different equipment makers. Vehicle manufacturers need to define a common specification to ensure that connectors designed and produced by the various equipment makers meet the same performance criteria and requirements. In the current design of this vehicle equipment, three areas of connection have been identified: — between the pyrotechnic device (e.g. initiator) and the harness connector; — between the tab holder and the clip holder of the harness connector; — between the harness connector and the electronic control module. The connection between the pyrotechnic device and the harness connector is the only connection that can be standardized and forms the subject of this document. Due to the location of the safety device in the vehicle, the connector design could be a right angle or straight. A sealed variant of the pyrotechnic device/initiator harness connector assembly is defined in Annex A. © ISO 2019 – All rights reserved

Scope: This document specifies the performance criteria and requirements of a three-way connection interface, including ground connection, linking the pyrotechnic device and harness connector built into a road vehicle. Performance criteria and requirements are defined for a sealed variant of the pyrotechnic device/ initiator harness connector assembly (see Annex A). Performance criteria and requirements are defined for a two-way (without ground) variant of the pyrotechnic device/initiator harness connector assembly (see Annex B). Performance criteria and requirements are defined for a variant without a retainer of the pyrotechnic device/initiator harness connector assembly is defined (see Annex C).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19072-2-2019 PDF

ISO 19072-2-2019 PDF

$60.00 $120.00