Testing of concrete - Part 2: Properties of fresh concrete
Introduction: International Standards are widely adopted at the regional or national level and applied by manufacturers, trade organizations, purchasers, consumers, testing laboratories, authorities and other interested parties. Since these documents generally reflect the best experience of industry, researchers, consumers and regulators worldwide and cover common needs in a variety of countries, they constitute one of the important bases for the removal of technical barriers to trade. However, full adoption may not be practicable in all cases for reasons, such as regional or national security, protection of human health or safety, or protection of the environment, or because of fundamental climatic, geographical or technological problems. As a consequence, the corresponding technical deviations to ISO standards are permitted where required by national or regional legislation or industry convention when adopting an International Standard. Where such national deviations are required, it is important that they are clearly identified and the reasons for the deviations stated. Depending of on the method of adoption of the International Standard, the deviations will be noted in the national introduction, in the preface or foreword (for small numbers) or as a national annex (for large numbers). See ISO/IEC Guide 21-1 for more information. ISO/TC 71/SC 1 has identified those items in this document that may be the subject of national or regional deviations. The items are indicated in the text by t
Scope: This document specifies procedures for testing fresh concrete. It specifies the following test methods: determination of consistence (slump test, Vebe test, degree of compactability, flow-table test for high‑fluidity concrete, and the slump-flow test), determination of fresh density and determination of air content by the pressure-gauge method and by the water-column method.