ISO 19323-2018 PDF

ISO 19323-2018 PDF

Timber structures - Joist hangers - Test methods

$71.50 $143.00 -50%
Product Code: ISO 19323
Stock In Stock
Edition: 1ST
Published: 09/2018
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Timber structures - Joist hangers - Test methods

Introduction: Joist hangers are an integral part of timber constructions in that they provide a necessary means of connection between timber elements and also between timber elements and other materials such as metal, concrete and masonry. Hangers are made predominantly from light gauge steel sheet which is electrolytically or hot-dipped galvanised and which is bent into a formed three-dimensional element – mostly U-shaped to allow for a bearing seat and lateral support to the joist. For high corrosion zones, stainless steel is often used in lieu of galvanised steel sheet. Hangers may also be made from welded steel plates. To provide a suitable connection, the joist hangers are capable of transferring forces in a range of directions depending on the make-up of the joint. Fasteners (e.g. nails, screws, bolts and dowels and proprietary fasteners) are inserted in the pre-punched or pre-drilled holes of the joist hanger plates (bearing seat, face and top plate) to secure the connection between the joint elements. The purpose of this document is to provide standard test procedures that can be used to determine the strength of a joint incorporating a joist hanger. © ISO 2018 – All rights reserved

Scope: This document provides standard test methods for determining the vertical load, axial load and torsional moment capacity as well as deflection characteristics of preformed three-dimensional joist hangers that are used primarily for securing one timber member to another (the header can be concrete or masonry). The joist hangers primarily transfer vertical loads from the supported member to the supporting member, but they can also be required to transfer axial loads from the supported member to the supporting member. NOTE 1 Structural steel sections can also be substituted as the header, but are not covered in this document. NOTE 2 One secondary mechanism to be considered is the effect of rotation of the supported member about its longitudinal axis on the joist hanger.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19323-2018 PDF

ISO 19323-2018 PDF

$71.50 $143.00