ISO 19683-2026 PDF

ISO 19683-2026 PDF

Space systems-Design qualification and acceptance tests of small spacecraft and units

$162.00 $324.00 -50%
Product Code: ISO 19683 (2026)
Stock In Stock
Edition: 2.
Published: 05/2026
Number of Pages: 102
File Size: 1 file, 8.9 MB

Available Options

Product Description

Space systems — Design qualification and acceptance tests of small spacecraft and units

Introduction: There is an increasing demand for small, micro, nano or pico satellite development and utilization worldwide; yet, there is no clear and globally accepted definition of what is considered “small”, “micro”, “nano” or “pico” satellites. These satellites are often built with emphasis on low cost and fast delivery. They are characterized by extensive use of non-space-qualified commercial-off-the-shelf (COTS) units (component). For the sake of convenience, the term “small spacecraft” is used throughout this document as a generic term to refer to these satellites. A small spacecraft is a satellite that utilizes non-traditional risk-taking development and management approaches to achieve low cost and fast delivery with a small number of team. To achieve these two points, low cost and fast delivery, satellite design relies on the use of non-space-qualified COTS units (components), making satellite size inherently smaller. The design accepts a certain level of risk associated with the use of COTS. Because of the risk taking approach, small spacecraft often fails in orbit. But the replacement spacecraft is quickly built and launched reflecting the lessons obtained in the previous spacecraft. As the launch cost depends on the spacecraft size and/or mass, the spacecraft size becomes “small”. Figure 1 illustrates the applicability of this document. Figure 1 — Applicability of this document A certain set of tests is necessary to ensure the mission success of small spacecraft. Applying the

Scope: This document provides test methods and test requirements for design either qualification or acceptance, or both of small spacecraft or units. It provides the minimum test requirements and test methods to qualify the design and manufacturing methods of commercial small spacecraft and their units and to accept the final products. This document is applicable to satellites whose development methods are different from the ones used for traditional satellites that have little room for risk tolerance. The scope of this document encompasses different categories of small spacecraft, so-called mini-, micro-, nano-, pico- and femto spacecraft. This document includes CubeSat, as long as it is developed with the untraditional processes. This document does not cover satellite deployment mechanisms, such as picosatellite orbital deployer (POD), as the verification requirements are defined in the interface control document (ICD) with the launcher, such as ISO 26869[1]. This document does not cover software testing, although some tests such as functional test, mission test and end-to-end test are inherently used to test the software installed in the hardware being tested. General requirements and processes of satellite software testing can be found in various references, such as ECSS-E- ST40[2]. This document does not cover requirements regarding safety nor debris mitigation. Appropriate documents such as ISO 14620-1[3] or ISO 24113[4] can be referred to. Other common requirements for small spacecraft can be found in ISO 20991[5].

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19683-2026 PDF

ISO 19683-2026 PDF

$162.00 $324.00