ISO 19880-5-2025 PDF

ISO 19880-5-2025 PDF

Gaseous hydrogen-Fuelling stations-Part 5: Dispenser hoses and hose assemblies

$113.50 $227.00 -50%
Product Code: ISO 19880-5
Stock In Stock
Edition: 2.
Published: 07/2025
Number of Pages: 36
File Size: 1 file, 2 Bytes

Available Options

Product Description

Gaseous hydrogen — Fuelling stations — Part 5: Dispenser hoses and hose assemblies

Introduction: This document specifies the implementation of performance-based testing for components of dispensing systems and fuelling stations that are based on proven engineering principles, research and the combined expertise of gas utilities, fuel providers, manufacturers, users, and others having specialized experience. The successful commercialization of hydrogen vehicle technologies requires codes and standards pertaining to fuelling stations, vehicle fuel system components, and the global homologation of standards requirements for technologies with the same end use. Essentially this will allow manufacturers to achieve economies of scale by producing one product for use globally. International harmonization contributes to reducing technical barriers and stimulates related markets. A series of documents that address hydrogen-fuelled vehicles and fuelling stations is being developed. These documents will provide internationally homologized minimum safety performance criteria at the component level, thus providing a foundation to build a safe “fuelling system”. This document is based on ANSI/CSA HGV 4.2-2022. This document was developed based on five pressure classes of wire or textile reinforced hoses and hose assemblies suitable for use with gaseous hydrogen for hydrogen dispensing. This is based on technologies in use at the time of the development of the requirements. In the future, other types and classes of hoses and hose assemblies will need to be evaluated to determine the sui

Scope: This document specifies the requirements for wire or textile reinforced hoses and hose assemblies suitable for dispensing hydrogen up to 70 MPa nominal working pressure, in the operating temperature range of −40 °C to 65 °C. This document specifies safety requirements for material, design, manufacture and testing of gaseous hydrogen hose and hose assemblies for hydrogen fuelling stations. This document does not apply to the following hoses and hose assemblies: a) those used as part of a vehicle high pressure on-board fuel storage system; b) those used as part of a vehicle low pressure fuel delivery system; and c) flexible metal hoses. NOTE 1 This document was developed primarily for hoses and hose assemblies for dispensing high-pressure hydrogen from refuelling dispensers to hydrogen vehicles. ISO 16964 addresses hoses used to deliver hydrogen from a transportable vessel (e.g. trailer) into a buffer storage of a station. NOTE 2 Hose assemblies include a hose with connectors on each end (see Figure 1). Each connector has two basic functional elements that are addressed as described below. a) Coupling to hose. This function is defined by requirements and verified (along with the hose itself) by performance-based tests in this document. b) Fitting for transition and connection to the piping system or equipment. This function is addressed by reference to appropriate hydrogen equipment standards and piping codes.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19880-5-2025 PDF

ISO 19880-5-2025 PDF

$113.50 $227.00