Additive manufacturing — Qualification principles — Test methods for metal casting sand moulds
Introduction: Additive manufacturing (AM) technology, which enables a part with a complex shape to be made without a master mould, has been applied to fabricate advanced sand moulds for metal casting. AM-made sand moulds have advantages in that it is possible to make cast parts not only with more precise dimensions, but also with thinner and complex shapes; therefore, application fields in the foundry industry are expanding. The difference between sand moulds and general mechanical/structural parts is that sand moulds are never used as final products. In other words, a sand mould is crushed after each casting process when its role ends. Therefore, sand moulds do not require long-term-stable properties, but specific properties for the casting process, such as having stiffness with a good balance between sufficient mechanical strength and crushability, as well as gas permeability and physical thermal properties for a hot environment. The test methods and dimensions of specimens are standardized in existing documents for conventionally made sand moulds, and they are applicable to AM-made sand moulds. However, these standards do not cover all aspects of sand moulds made by AM, where uneven properties due to location in a build space and variations in process conditions between build cycles, as well as anisotropy due to a layer-by-layer process also can have a significant effect of the properties of the sand mould. This document provides practices for sampling specimens of AM-made sand moulds,
Scope: This document specifies test methods for metal casting sand moulds produced using additive manufacturing technologies, with mechanical and physical properties including, but not limited to, tensile strength, transverse strength, gas permeability and thermal expansion.