ISO/ASTM 52936-1-2023 PDF

ISO/ASTM 52936-1-2023 PDF

Additive manufacturing of polymers-Qualification principles-Part 1: General principles and preparation of test specimens for PBF-LB

$31.50 $63.00 -50%
Product Code: ISO/ASTM 52936-1
Stock In Stock
Edition: 1.
Published: 01/2023
Number of Pages: 12
File Size: 1 file, 888 Bytes

Available Options

Product Description

Additive manufacturing of polymers — Qualification principles — Part 1: General principles and preparation of test specimens for PBF-LB

Introduction: Many factors in an additive manufacturing test specimen-preparation process can influence the properties of the test specimens prepared and hence the measured values obtained when the test specimens are used in a test method. The mechanical properties of such test specimens are in fact strongly dependent on the conditions of the process used to prepare the test specimens. Exact definition of each of the main parameters of the process is a basic requirement for reproducible operating conditions. It is important in defining test specimen-preparation conditions to consider any influence the conditions could have on the properties to be determined. Test specimens prepared by additive manufacturing techniques can show differences in molecular morphology (as with crystalline and semicrystalline polymers), differences in powder morphology (after undergoing a sintering process, for instance), differences in thermal history and differences in thickness of the layers, test specimen orientation or test specimen location, used to prepare the specimen. Only if each of these is controlled can differences in the values of the properties measured be avoided. © ISO/ASTM International 2023 – All rights reserved

Scope: This document specifies the general principles to be followed when test specimens of thermoplastic materials are prepared by laser-based powder bed fusion (PBF-LB/P), which is commonly known as laser sintering. The (PBF-LB/P) process is used to prepare test specimens layer upon layer in which thermal energy selectively fuses regions of a powder bed. This document provides a basis for establishing reproducible and reportable sintering conditions. Its purpose is to promote uniformity in describing the main process parameters, build orientation of the sintering process and also to establish uniform practice in reporting sintering conditions. This document does not specify the test procedure itself.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO/ASTM 52936-1-2023 PDF

ISO/ASTM 52936-1-2023 PDF

$31.50 $63.00