Information technology — Radio frequency identification for item management — Part 63: Parameters for air interface communications at 860 MHz to 930 MHz Type C
Introduction: A radio frequency identification (RFID) system comprises: — Interrogators, also known as radio identification (RAIN) Readers, and — RAIN Tags, also known as RAIN Labels or RAIN Transponders. This document is also referred as RAIN Air Interface. For more information on RAIN, see Annex S. A RAIN Interrogator transmits information to a RAIN Tag by modulating an RF signal in the 860 MHz to 930 MHz frequency range. The Tag receives both information and operating energy from this RF signal. Tags are passive, which means that they receive all of their operating energy from the Interrogator’s RF signal. A RAIN Interrogator receives information from a RAIN Tag by transmitting a continuous wave (CW) RF signal to the Tag; the Tag responds by modulating the reflection coefficient of its antenna, thereby backscattering an information signal to the Interrogator. The system is Interrogator-talks-first (ITF), which means that a Tag modulates its antenna reflection coefficient with an information signal only after being directed to do so by an Interrogator. Interrogators and Tags are not required to talk simultaneously; rather, communications are half-duplex, i.e. Interrogators talk and Tags listen, or vice versa. The backscatter RFID system described in this document supports the following system capabilities: — identification and communication with multiple tags in the field; — selection of a subgroup of tags for identification or with which to communicate; — reading from and writing to or
Scope: This document establishes the air interface for radio frequency identification (RFID) devices operating in the 860 MHz to 930 MHz industrial, scientific and medical (ISM) band used in item management applications. This document specifies a common technical specification for RFID devices that can be used to develop standards for applications using this radio identification (RAIN) air interface. This document is intended to improve compatibility and encourage inter-operability of products for the growing RFID market in the international marketplace. This document establishes the forward and return link parameters for technical attributes including, but not limited to, operating frequency, operating channel accuracy, occupied channel bandwidth, maximum effective isotropic radiated power (EIRP), spurious emissions, modulation, duty cycle, data coding, bit rate, bit rate accuracy, bit transmission order, and, where appropriate, operating channels, frequency hop rate, hop sequence, spreading sequence, and chip rate. This document further specifies the communications protocol used in the air interface. This document describes the physical and logical requirements for a passive backscatter, Interrogator-talks- first (ITF), radio frequency identification system operating in the 860 MHz to 930 MHz frequency range. This document specifies: — physical interactions (the signalling layer of the communication link) between Interrogators and Tags; — logical operating procedures and commands between Interrogators and Tags; — the collision arbitration scheme used to identify a specific tag in a multiple-tag environment; — optional security commands that allow the use of crypto suites of ISO/IEC 29167-1:2014 [1].