Information technology — Radio frequency identification device conformance test methods — Part 63: Test methods for air interface communications at 860 MHz to 960 MHz
Introduction: The ISO/IEC 18000 series defines the air interface for radio frequency identification (RFID) devices used in item management applications. ISO/IEC 18000-61, ISO/IEC 18000-62, ISO/IEC 18000-63 and ISO/IEC 18000-64 define the air interface for RFID devices that operate at frequencies from 860 MHz to 960 MHz The ISO/IEC 18047 series provides air interface communication test methods to ensure conformance with the different parts of the ISO/IEC 18000 series. Each part of the ISO/IEC 18047 series contains all measurements required to be made on a product to establish whether it conforms to the corresponding part of the ISO/IEC 18000 series. NOTE Test methods for interrogator and tag performance are covered by the ISO/IEC 18046 series. This document specifies the conformance requirements for a passive-backscatter, interrogator- talks-first (ITF), radio-frequency identification (RFID) system operating in the 860 MHz to 960 MHz frequency range. The system comprises interrogators, also known as readers, and tags, also known as labels. An Interrogator transmits information to a Tag by modulating a radiofrequency (RF) signal in the 860 MHz to 960 MHz frequency range. The Tag receives both information and operating energy from this RF signal. Tags are passive, meaning that they receive all of their operating energy from the Interrogator’s RF waveform. An Interrogator receives information from a Tag by transmitting a continuous-wave (CW) RF signal to the Tag; the Tag responds by modulating
Scope: This document specficies test methods for determining the conformance of radio frequency identification (RFID) devices (tags and interrogators) for item management with the specifications given in ISO/IEC 18000-63. This document does not apply to the testing of conformity with regulatory or similar requirements. The test methods specify only the verification of the mandatory functions and any optional functions which are implemented. This can, in appropriate circumstances, be supplemented by further, application-specific functionality criteria that are not available in the general case. The interrogator and tag conformance parameters in this document are the following: — type-specific conformance parameters including nominal values and tolerances; — parameters that directly affect system functionality and inter-operability. Parameters that are already included in regulatory test requirements are not included in this document. Unless otherwise specified, the tests in this document are intended to be applied exclusively to RFID tags and interrogators defined in ISO/IEC 18000-63.