Office equipment — Print quality measurement methods for colour prints — Part 2: Registration and magnification accuracy
Introduction: Measurement methods that quantitatively evaluate geometric property attributes of duplex print sets need to be standardized, as most of the office documents are currently printed as duplex print sets comprising several sheets printed colour images on both surface of substrates. There are several standard measurement methods to evaluate image quality attributes of printed images formed by office equipment, i.e. colour reproductions, line reproductions, image structures of sharpness and graininess, gloss properties. Included are ISO/IEC 19799, ISO/IEC 24790 and ISO/IEC 29112. ISO/IEC 24790 specifies the measurement methods for large area density uniformity of graininess, mottle and banding, as well as line qualities. ISO/IEC 29112 specifies methods for measuring sharpness attributes of edge blurriness and raggedness, special frequency response, etc. ISO/IEC 19799 specifies the methods for gloss uniformity. By utilizing those documents, users can obtain consistent test results when they comply with the protocols specified in the documents. While there are no standard methods to measure colour reproduction consistencies and geometrical accuracies in consecutive printing, and image stabilities in typical use case of print images formed by office equipment and used in office environments. In the current state, each printer distributer and its user can provide test results for those attributes measured by its own test methods and procedures, which are often convenient for its produc
Scope: This document specifies test methods as well as test charts to measure the geometric property attributes and those variations in duplex colour prints typically used in office environment. This document is applicable to duplex prints comprising several sheets which are printed colour images on both surfaces of a substrate. “Within-page variation” and “sheet-to-sheet variation” are also applicable for a simplex print set comprising several sheets, which are printed colour images on one surface of a substrate and no image on the other surface. Prints with four primary colourants other than cyan, magenta, yellow and black are outside the scope of this document. Included are digital prints formed by using a multifunction or single function printer. When a duplex print set is evaluated, duplex printers which are capable to print images on both sides of substrate automatically are applicable, while simplex printers which require a manual arrangement of substrates between the front side and back side printing to form duplex prints are out of scope of this document. The printers of the maximum applicable substrate size of A4 or larger are suitable for the measurements. The geometric property attributes included are registration and magnification of a print set. Microscopic geometrical density variations, such as graininess, mottle and line raggedness, are outside the scope of this document. The sources of variations considered are locations in a page, print side in a sheet, print order of sheets in a print set, and variations among primary colours.