Software Engineering - Lifecycle profiles for Very Small Entities (VSEs) - Part 2-1: Framework and taxonomy
Introduction: Very Small Entities (VSEs) around the world are creating valuable products and services. For the purpose of this part of ISO/IEC 29110, a Very Small Entity (VSE) is an enterprise, an organization, a department, or a project having up to 25 people. Since many VSEs develop and/or maintain system and software components used in systems, either as independent products or incorporated in larger systems, a recognition of VSEs as suppliers of high quality products is required. According to the Organization for Economic Co-operation and Development (OECD) SME and Entrepreneurship Outlook report (2005), “Small and Medium Enterprises (SMEs) constitute the dominant form of business organization in all countries world-wide, accounting for over 95 % and up to 99 % of the business population depending on country”. The challenge facing governments and economies is to provide a business environment that supports the competitiveness of this large heterogeneous business population and that promotes a vibrant entrepreneurial culture. From studies and surveys conducted, it is clear that the majority of International Standards do not address the needs of VSEs. Implementation of and conformance with these standards is difficult, if not impossible. Consequently, VSEs have no, or very limited, ways to be recognized as entities that produce quality systems/system elements including software in their domain. Therefore, VSEs are excluded from some economic activities. It has been found that VSEs find i
Scope: 1.1 Fields of application ISO/IEC 29110 is applicable to Very Small Entities (VSEs). The lifecycle processes described in ISO/IEC 29110 are not intended to preclude or discourage their use by organizations bigger than VSEs. However, certain issues faced by large organizations might not be covered by ISO/IEC 29110. The lifecycle processes defined in ISO/IEC 29110 can be used by VSEs when acquiring and using, as well as when creating and supplying, a software, and systems. They can be applied at any level in a software and systems structure and at any stage in the lifecycle. The processes described in ISO/IEC 29110 are not intended to preclude or discourage the use of additional processes that VSEs find useful. This part of ISO/IEC 29110 introduces the major concepts for software and systems engineering profiles for VSEs, and defines the terms common to the set of documents associated with VSE profiles. It establishes the logic behind the definition and application of profiles. It specifies the elements common to all standardized profiles (structure, conformance, assessment). This part of ISO/IEC 29110 is applicable to all profiles. 1.2 Target audience This part of ISO/IEC 29110 is targeted at authors and reviewers of standardized profiles, authors of other parts, and authors of other VSE profiles. 2 Conformance to standardized profiles 2.1 Overview Conformance is specified within each profile specification document, published as ISO/IEC 29110-4-61) for systems engineering and ISO/IEC 29110-4-1 for software engineering. The general rules for conformance to ISO/IEC 29110 profiles are in accordance with ISO/IEC TR 10000-1 and outlined in 2.2 and 2.3. 2.2 General principles 2.2.1 Tailoring and exclusions ISO/IEC 29110 standardized profiles are pre-tailored packages of related software and systems engineering standards, therefore — tailoring of ISO/IEC 29110 profiles is not needed nor allowed (except in one case outlined in 2.3.2), — partial compliance is not allowed (except in one case outlined in 2.2.3), and 1) To be published. INTERNATIONAL STANDARD ISO/IEC 29110-2-1:2015(E) © ISO/IEC 2015 – All rights reserved ISO/IEC 29110-2-1:2015(E) — there are no levels of c