Information technology - Telecommunications and information exchange between systems - High-level data link control (HDLC} procedures Elements of procedures
Introduction: General High-level data link control (HDLC) procedures are designed to permit synchronous or start/stop, code-transparent data transmission. This International Standard describes the HDLC elements of procedures. Further studies are in progress to identify and define additional elements of procedures which may be included at a later date. In HDLC procedures, the normal cycle of the code-transparent data communication between two data stations consists of the transfer of frames containing information from the data source to the data sink acknowledged by a frame in the opposite direction. Until the data station comprising the data source receives an acknowledgement, it holds the original information in memory in case the need should arise for retransmissions. Data sequence integrity between the data source and the data sink is effected by means of a numbering scheme, which is cyclic within a modulus specified in this International Standard and measured in terms of frames. An independent numbering scheme is used for each data source/data sink combination on the data link. The acknowledgement function is accomplished by the data sink informing the data source of the next expected sequence number. This can be done in a separate frame, not containing information, or within the control field of a frame containing information. HDLC procedures are applicable to unbalanced data links and to balanced data links. Unbalanced data links An unbalanced data link involves two or more participa
Scope: This International Standard specifies elements of data link control procedures for synchronous or start/stop, code- transparent data transmission using the HDLC frame structure specified in ISO 33()1) and independent frame numbering in both directions. These HDLC elements of procedures are defined specifically in terms of the actions that occur on receipt of commands at a secondary station or a combined station. This International Standard is intended to cover a wide range of applications; for example one-way, two-way alternate or two-way simultaneous data communication between data stations which are usually buffered, including operations on different types of data circuits; for example multipoint/point- to-point, duplex/half-duplex, switched/non-switched, synchronous/start-stop, etc. The defined HDLC elements of procedures are to be considered as a common basis for establishing different types of control procedures. This International Standard does not define any single system and should not be regarded as a specification for a data communication system. Not all of the commands or responses are required for a particular system implementation.
Contents:
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Definitions
- 4 Data link channel states
- 5 Modes
- 6 Control field and parameters
- 7 Commands and responses
- 8 Exception condition reporting and recovery