ISO/IEC 7810-2019 PDF

ISO/IEC 7810-2019 PDF

Identification cards-Physical characteristics

$13.00 $26.00 -50%
Product Code: ISO/IEC 7810
Stock In Stock
Edition: 4.
Published: 12/2019
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Identification cards — Physical characteristics

Introduction: This document defines the minimum physical requirements for the identification card and is used by the following identification card standards for recording technologies. Other standards not listed here may also refer to this document. — ISO/IEC 7501 (all parts), Identification cards — Machine readable travel documents — ISO/IEC 7811 (all parts), Identification cards — Recording technique — Embossing and magnetic stripes — ISO/IEC 7812 (all parts), Identification cards — Identification of issuers — ISO/IEC 7813, Identification cards — Financial transaction cards — ISO/IEC 7816 (all parts), Identification cards — Integrated circuit(s) cards with contacts — ISO/IEC 10373 (all parts), Identification cards — Test methods — ISO/IEC 10536 (all parts), Identification cards — Contactless integrated circuit(s) cards — Close- coupled cards — ISO/IEC 14443 (all parts), Identification cards — Proximity integrated circuit(s) cards — ISO/IEC 15693 (all parts), Identification cards — Vicinity integrated circuit(s) cards — ISO/IEC 11693-1, Identification cards — Optical memory cards — Part 1: General characteristics — ISO/IEC 11694 (all parts), Identification cards — Optical memory cards — Linear recording method — ISO/IEC 24789 (all parts), Identification cards — Card service life — ISO/IEC 18328 (all parts), Identification cards — ICC-managed devices NOTE Notes in this document are only used for giving additional information intended to assist in the understanding or use of this document a

Scope: This document describes the characteristics for identification cards and the use of such cards for international interchange. This document specifies the physical characteristics of identification cards including card materials, construction, characteristics and dimensions for four sizes of cards. ISO/IEC 10373-1 and ISO/IEC 24789-2 specify the test procedures used to check cards against the parameters specified in this document. This document specifies the requirements for cards and card interface devices used for identification. It takes into consideration both human and machine aspects and states minimum requirements. It is the purpose of this document to provide criteria for the performance of cards. No consideration is given within this document to the amount of use, if any, experienced by the card prior to test. NOTE 1 Numeric values in the SI and/or Imperial measurement system in this document have been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system can be used, but intermixing or reconverting the two can result in errors. The original design was made using the Imperial measurement system. NOTE 2 Thin flexible cards are not within the scope of this document (see the ISO/IEC 15457 series).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO/IEC 7810-2019 PDF

ISO/IEC 7810-2019 PDF

$13.00 $26.00